Help with Mypin TD4-SNR PID. Overshooting temp by large amount

※ Download: Mypin td4-snr manual

Brew on Thanks for the quick reply Doug. When power is on, the jumper then enables the heat to be turned on. Brew on Posted May 5, 2017 The black jumper provides power to the bottom switch when the top switch is turned on.

Now it will bounce from the target by only about 3 degrees on average. Are you circulating at all during your mash? Other than that, I'm out of the running for ideas.

Help with Mypin TD4-SNR PID. Overshooting temp by large amount - Now it will bounce from the target by only about 3 degrees on average.

How to Connect and Set PID Temperature. Controller? ITC-100VH
I do not know what is wrong and I am going crazy! That's didn't help, so it's not probe placement. The design below shows this. Ads help to support this site and we would appreciate if you would turn off AdBlocker for Homebrew Talk. It doesn't take much to warm the mash tun 1°F. But it wasn't allowing me to manually adjust the percentage.